Kronos Robotics

I just used Cut 2D and created a big square 1/8 deep, that is it... ;-) I use the sacrificial board like I use to on the 80/20 bed, just put it under the material and clamp it down. If I do engraving, I just put it on the bed... It's a little bit of a hassle to use the holes and lock the T-Bolts but...

That is pretty much what I did when leveling my bed.
http://www.krforums.com/forums2/viewtopic.php?t=1376

I still use a sacrificial board since I don't want to mess up the leveling but the MDF board itself could be used as a sacrificial board and easily be re-surfaced if needed...

Found an interesting article,
http://blog.makezine.com/2012/04/13/cnc ... -notebook/

Which led me to another interesting link as well,
http://www.flexiblestream.org/Digital-W ... ts-001.php

Yes, that would be very helpful...

I'm still experimenting with different RPMs and feedrates and it mostly comes out OK.
I should probably do some research on-line to see if I can get some more information...

I got around to read it as well, nice work.
Looking forward to the next part as well.

I'm very tempted to build one, luckily X-mas is around the corner...

Looks nice but I think I'll keep my $25 Logitech controller...
I like the fact that the joystick controls the speed proportional on my controller, I would not give that up.

Looks nice but I think I'll keep my $25 Logitech controller...
I like the fact that the joystick controls the speed proportional on my controller, I would not give that up.

That is a great video, specially since I'm getting ready to paint my 3x3 angles tomorrow. I asked for a Zinc based primer at Home Depot and they showed me "Cold Galvanizing Compound" from Rust-Oleum which make sense so I bought a couple of cans. The can is very heavy for it's size by the w...