Clean Edges (TIP)

Post Reply
msimpson
Site Admin
Posts: 3176
Joined: Tue Mar 30, 2004 6:19 pm

Clean Edges (TIP)

Post by msimpson »

Oftain when CNCing a part you will get fibers on the edges of the cut. I found the fastest way to clean them up is to take a small palm sander with 120-180 grit paper and to sand the surface whil it is still attached to the waste. (tabs still intact)

Just a quick sanding of 10-20 seconds will make those edges clean and crisp.
Post Reply

Return to “General CNC”