I”m thinking of getting this chuck for my hitachi so I can use some lower cost bits. This is the chuck I 'm thinking about for my Hitachi M12VC http://www.precisebits.com/products/equ ... !!Kit!!!PG!!!
I,m hoping to use 1/8 sized bits at a lower cost, and buy some of these.
http://www.aliexpress.com/store/product ... 65473.html
Thoughts?
Lower cost bits
-
- Posts: 494
- Joined: Mon Dec 31, 2012 11:07 am
-
- Posts: 494
- Joined: Mon Dec 31, 2012 11:07 am
Yes, $30 is about right.
I was commenting that a "single bit" at $50 was expensive, more than the Onsrud. Then I realized the offer was for 5 bits, so $10 a bit, which is less than the Onsrud by a decent amount.
For me, I prefer the Onsrud over a Chinese bit, but that more a political thing than a practical one. And I don't discuss politics in writing
I was commenting that a "single bit" at $50 was expensive, more than the Onsrud. Then I realized the offer was for 5 bits, so $10 a bit, which is less than the Onsrud by a decent amount.
For me, I prefer the Onsrud over a Chinese bit, but that more a political thing than a practical one. And I don't discuss politics in writing