Page 1 of 1

CNC Plant Hanger Project

Posted: Mon Apr 27, 2020 5:59 pm
by msimpson
I just finished a CNC project where I made 10 hanging pot holders for my front porch. I made them strictly from scraps I had on hand as well as hardware I could scrounge up.
_MG_8224.jpg
You can see the writeup here:
http://www.kronosrobotics.com/planterhanger

Please feel free to share the link to this project where you can. Every little bit helps.

Re: CNC Plant Hanger Project

Posted: Wed Apr 29, 2020 4:00 pm
by mbonadio
I submitted it to Hackaday and got a response that it will go out in the next day or so. I got a nice response from the writer...

Michael,

A few months ago people might have looked at this and called it a waste of time. Now that materials are getting more difficult to come by and people are trying to complete projects with what's on hand, efficiency improvements like this are crucial. Most of us have plenty of time right now, so why not put in the extra effort if it means avoiding a trip to the store.

Post is written up for this now, and it should hit the site in the next day or so. Thanks for sending it our way.

Re: CNC Plant Hanger Project

Posted: Wed Apr 29, 2020 8:03 pm
by msimpson
Thanks Michael

Re: CNC Plant Hanger Project

Posted: Wed May 06, 2020 11:07 am
by mbonadio